Disassembly for Storage, Removal or Moving
Tell NY-GoodHome whether the parts need to be preserved for later use. A trampoline headed for disposal can be broken down differently from one that must be reassembled. If the product will move to another property, the destination and transport arrangements should be stated separately.
Enclosure, Mat, Springs and Frame Breakdown
Disassembly normally moves from enclosure/accessories to mat tension components and then the frame, following the product system. Springs, rods and frame joints can be under tension, so the sequence matters. The page does not promise recovery of parts that are already damaged or seized.
Part Labeling and Hardware Storage
For reuse, components can be grouped and labeled by frame section, enclosure position and hardware set. Bags or containers should be available for fasteners. NY-GoodHome does not guarantee that older proprietary hardware can be replaced if it is missing during disassembly.
Condition, Rust and Stuck Components
Outdoor exposure can cause corrosion, bent frame joints or stuck fasteners. Send photos of visible damage before scheduling. Severely rusted parts may not disassemble cleanly, and a product that is structurally compromised should not be treated like a normal reusable system.
Haul-Away and Reassembly Boundaries
This service does not automatically include removal from the property, disposal or installation at a new site. New assembly uses Trampoline Assembly, and broader products are under Outdoor Assembly. Use Contact with photos and state whether the parts are being stored, moved or discarded.
Before Disassembly
Confirm the approximate diameter/size and whether the trampoline is above ground, anchored or partly buried. If anchors, concrete or in-ground components are present, identify them before the job is scoped.
Project Details to Confirm
State whether the trampoline is going into storage, being transported for reuse or being discarded. Show any ground anchors and note corrosion, bent frame sections or seized joints. If components must remain reusable, provide containers for hardware and enough space to label sections; hauling and disposal should be arranged separately unless explicitly added.